48GX serial comms (Mac)
|
02-09-2019, 05:34 PM
Post: #2
|
|||
|
|||
RE: 48GX serial comms (Mac)
The 48 supports Kermit natively. If you want it to do XMODEM then you need to install a library that the official ConnKit transfers to the calculator.
Archival of data on the 48 is similar to the 50g. Just place a global name in one of the ports (e.g. :0: MEM) and run ARCHIVE. If you then recall that object to the stack (you'll see that it's just a directory object) and store it in a HOME variable, you can then transfer it to your computer as you would any other variable. The down-side is, you can only do this as long as your calculator is less than half full! |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
48GX serial comms (Mac) - cdmackay - 02-09-2019, 03:40 PM
RE: 48GX serial comms (Mac) - grsbanks - 02-09-2019 05:34 PM
RE: 48GX serial comms (Mac) - cdmackay - 02-09-2019, 07:05 PM
RE: 48GX serial comms (Mac) - Raymond Del Tondo - 02-09-2019, 08:18 PM
RE: 48GX serial comms (Mac) - Sylvain Cote - 02-09-2019, 06:57 PM
RE: 48GX serial comms (Mac) - cdmackay - 02-09-2019, 07:06 PM
RE: 48GX serial comms (Mac) - cdmackay - 02-09-2019, 08:23 PM
RE: 48GX serial comms (Mac) - Giuseppe Donnini - 02-09-2019, 09:13 PM
RE: 48GX serial comms (Mac) - cdmackay - 02-09-2019, 10:54 PM
|
User(s) browsing this thread: 1 Guest(s)