HP Classic Calculator (HP-65) back label
|
03-03-2019, 11:18 PM
Post: #15
|
|||
|
|||
RE: HP Classic Calculator (HP-65) back label
(03-03-2019 09:49 PM)albertofenini Wrote: It is not bad being our first try but it is far from the original look. I agree, not perfect, but this is quite good, better than almost all I've seen, after the corners have been pulled down to access the screws. I've read one successful technique for preparing the label (to flatten it) is to slowly rub it with a teaspoon on some kind of flat metal surface (stove, piece of thick sheet metal, etc.). But it does appear the spray glue worked well, the edges do not appear to be lifting or peeling. Can the edge of the label be felt in your hand while holding/handling the unit? --Bob Prosperi |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 2 Guest(s)