HP41 keyboard overlay model for 3d printer
|
11-14-2018, 03:24 PM
Post: #3
|
|||
|
|||
RE: HP41 keyboard overlay model for 3d printer
With a couple very minor tweaks to the layout, you can make it reversible, so both sides can be used.
Required mods: 1. Remove the vertical bar between the 2 rightmost holes in the 4th row down. 2. Slightly enlarge the horizontal width on the right edge of the leftmost 3 columns of the bottom 4 rows. Though not apparent with casual use, it is easily seen (just turn one over to check fit) that the number keys are not spaced uniformly due to the larger size of the digit keys. --Bob Prosperi |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
HP41 keyboard overlay model for 3d printer - Astro3D - 11-14-2018, 10:51 AM
RE: HP41 keyboard overlay model for 3d printer - burkhard - 11-14-2018, 03:17 PM
RE: HP41 keyboard overlay model for 3d printer - Astro3D - 11-14-2018, 05:15 PM
RE: HP41 keyboard overlay model for 3d printer - rprosperi - 11-14-2018 03:24 PM
RE: HP41 keyboard overlay model for 3d printer - Harald - 11-15-2018, 10:22 AM
RE: HP41 keyboard overlay model for 3d printer - Astro3D - 11-15-2018, 11:21 AM
|
User(s) browsing this thread: 1 Guest(s)