Damaged HP 9810A

[Katie Wasserman]

(05-03-2014 12:02 AM)douze-bis Wrote:  One question : did you consider using a cut of tygon tubing instead of O-rings ?
It would give a "square" section instead of a "round" section, and might be closer to the original wheel ?
Maybe it would be more difficult to fit onto the wheels ?

I use silicon rubber tubing for the 65/67/97/41 card readers iinstead of the common o-ring replacement and find it works great. If you use it for the 9810 reader making sure it stays in place without gluing it down might be an issue.