HP Forums / HP Calculators (and very old HP Computers) / HP Prime v / "for" cycle as a function command

Post Reply 
"for" cycle as a function command
11-13-2018, 08:44 AM
Post: #2
ijabbott Offline
Senior Member
 		Posts: 1,293
Joined: Jul 2015
RE: "for" cycle as a function command
(11-12-2018 08:42 PM)compsystems Wrote:  Hello
Xcas supports the definition of the "for" cycle as a function command FOR() ;, for many this type of instructions is more compact and readable, as IFTE() function cmd.

It's not really a function. It's just syntactic sugar to appease programmers familiar with C-like syntax a little bit.
— Ian Abbott
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: "for" cycle as a function command - ijabbott - 11-13-2018 08:44 AM



User(s) browsing this thread: 1 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication