Post Reply 
Which libraries do you use / would you recommend on your calculator?
05-01-2018, 12:55 PM
Post: #5
RE: Which libraries do you use / would you recommend on your calculator?
(05-01-2018 12:20 PM)grsbanks Wrote:  If you're doing any SysRPL or ASM dev work on a 48/49/50g then the 'extable' library is an absolute must. Easily found with a cursory search on the internet.

Nosy is also very useful as a learning tool to see how things are done in the firmware of the 50g. In a similar fashion, Jazz on the 48-series.

I'm glad to see that there is someone other than me still using MultiStopwatch, Pier! I don't use it to time calculator operations (I usually use TEVAL for that), but I've been surprised how often I end up timing some occasional activity. Usually when I'm trying to decide if I want to proceed with some repetitive task, which inevitably takes longer than I think. It's probably the most-used software on my 49g+ on a long-term basis.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Which libraries do you use / would you recommend on your calculator? - DavidM - 05-01-2018 12:55 PM



User(s) browsing this thread: 1 Guest(s)