3d-printing a thinner HP41CX back cover

Threaded Mode | Linear Mode

3d-printing a thinner HP41CX back cover

02-27-2018, 07:58 AM

Post: #7

brickviking Offline

Senior Member

Posts: 336
Joined: Dec 2014

RE: 3d-printing a thinner HP41CX back cover

(02-27-2018 07:48 AM)Massimo Gnerucci Wrote:
(02-27-2018 04:58 AM)Nate Martin Wrote: I just checked my boneyard and have about a half-dozen full nuts in various states of repair but no half nuts.

Isn't a half-dozen full nuts = a dozen half nuts?

Sigh. That's just nuts...

(Post 183)

Regards, BrickViking
HP-50g |Casio fx-9750G+ |Casio fx-9750GII (SH4a)

« Next Oldest | Next Newest »

Messages In This Thread

3d-printing a thinner HP41CX back cover - atilla457 - 02-26-2018, 04:52 PM

RE: 3d-printing a thinner HP41CX back cover - rprosperi - 02-26-2018, 05:57 PM

RE: 3d-printing a thinner HP41CX back cover - Didier Lachieze - 02-26-2018, 07:02 PM

RE: 3d-printing a thinner HP41CX back cover - hth - 02-26-2018, 07:29 PM

RE: 3d-printing a thinner HP41CX back cover - Nate Martin - 02-27-2018, 04:58 AM

RE: 3d-printing a thinner HP41CX back cover - Massimo Gnerucci - 02-27-2018, 07:48 AM

RE: 3d-printing a thinner HP41CX back cover - brickviking - 02-27-2018 07:58 AM

RE: 3d-printing a thinner HP41CX back cover - grsbanks - 02-27-2018, 11:01 AM

RE: 3d-printing a thinner HP41CX back cover - Massimo Gnerucci - 02-27-2018, 11:42 AM

RE: 3d-printing a thinner HP41CX back cover - Paul Dale - 02-27-2018, 08:04 AM

RE: 3d-printing a thinner HP41CX back cover - toml_12953 - 02-27-2018, 01:19 PM

User(s) browsing this thread: 1 Guest(s)