Post Reply 
82240B printhead fried itself in a puff of smoke
03-23-2020, 11:52 PM
Post: #39
RE: 82240B printhead fried itself in a puff of smoke
New printhead part received, surgery performed.
...
Success - it prints once more!
  • Performed the printer's self-test - "with the printer off, hold down the line-feed button, turn the printer on, and then release line-feed". OK
  • Printed from my DM42 to the printer via infra-red. OK.
The only remaining question I have before I screw it all back together is this small sheet of plastic I found inside the case. It was likely in there before but I don't know where to put it. It has a distinct square edge which suggests it sits somewhere and is held in place - is it meant to protect some component inside?

[Image: HP%20thermal%20printer%20plastic%20sheet...jpeg?raw=1]
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: 82240B printhead fried itself in a puff of smoke - tcab - 03-23-2020 11:52 PM



User(s) browsing this thread: 1 Guest(s)