Post Reply 
HP 21 repair
06-15-2015, 01:28 AM
Post: #1
HP 21 repair
Just found my college calculator from 1975 which has been in the attic for over 10 years fortunately with the battery pack out of it.

I followed the instructions here to remove old batteries and replaced first with alkaline then with rechargeable batteries. With the alkaline I did get the LEDs to light up after awhile but no function of the cal. Nothing happened with the Niad batteries.

I took the device apart and found that a piece of foam that was between the two PCB had corroded and when I removed it found several traces damaged on the PCB's.

Is there anything to be done or do I just write it off? Is this repairable?

I really like this calculator and have an attachment to it especially now that I have found it again.

Any advice is appreciated.

Thanks,

mk
Find all posts by this user
Quote this message in a reply
06-15-2015, 01:46 AM
Post: #2
RE: HP 21 repair
I've been experimenting with conductive ink pens to repair damaged traces.
Find all posts by this user
Quote this message in a reply
06-15-2015, 01:55 AM
Post: #3
RE: HP 21 repair
I saw them when I did a search for "circuit board repair". More negatives than positives.

If they work that would help me a lot.

How does it work for you?
Find all posts by this user
Quote this message in a reply
06-15-2015, 02:14 AM
Post: #4
RE: HP 21 repair
(06-15-2015 01:55 AM)surgdog Wrote:  How does it work for you?

I've been trying to use it to repair a Thinkjet flex cable.

[Image: Printhead%2BRepaired.jpg]

So far it works.

Dave
Find all posts by this user
Quote this message in a reply
06-15-2015, 02:56 AM
Post: #5
RE: HP 21 repair
(06-15-2015 01:28 AM)surgdog Wrote:  Is there anything to be done or do I just write it off? Is this repairable?

If only some traces on the main board are damaged, they can be repaired with isolated copper wire (german Kupferlackdraht). The HP-21 main board is easily accessible for repairs. If the ACT chip is damaged, you can replace it by the "new ACT". Your HP-21 is most likely repairable. Don't write it off!

Bernhard

That's one small step for a man - one giant leap for mankind.
Find all posts by this user
Quote this message in a reply
06-15-2015, 11:10 AM (This post was last modified: 06-15-2015 04:06 PM by isanchez.)
Post: #6
RE: HP 21 repair
Hi,

I have been using "conducting silver"( http://www.amazon.co.uk/Conducting-Silve...B000YJ2P2I )
to repair the keyboard circuit of an HP41C, successfully. It must be applied with a very small and thin brush. It gets dry in half an hour and is very effective and reliable..

Kind regards

Igancio
Find all posts by this user
Quote this message in a reply
06-15-2015, 03:16 PM
Post: #7
RE: HP 21 repair
(06-15-2015 02:56 AM)PANAMATIK Wrote:  
(06-15-2015 01:28 AM)surgdog Wrote:  Is there anything to be done or do I just write it off? Is this repairable?

If only some traces on the main board are damaged, they can be repaired with isolated copper wire (german Kupferlackdraht). The HP-21 main board is easily accessible for repairs. If the ACT chip is damaged, you can replace it by the "new ACT". Your HP-21 is most likely repairable. Don't write it off!

Bernhard

Forgive my ignorance but what is the "new ACT"?
Find all posts by this user
Quote this message in a reply
06-15-2015, 05:30 PM
Post: #8
RE: HP 21 repair
(06-15-2015 03:16 PM)surgdog Wrote:  Forgive my ignorance but what is the "new ACT"?

Bernhard has created a replacement circuit for the processor (ACT) in some older HP calculators. The chip is prone to fail under not so rare circumstances. This is the thread: ACT available

Marcus von Cube
Wehrheim, Germany
http://www.mvcsys.de
http://wp34s.sf.net
http://mvcsys.de/doc/basic-compare.html
Find all posts by this user
Quote this message in a reply
Post Reply 




User(s) browsing this thread: 1 Guest(s)