HP-41 page 7 safety - Printable Version +- HP Forums (https://www.hpmuseum.org/forum) +-- Forum: HP Calculators (and very old HP Computers) (/forum-3.html) +--- Forum: General Forum (/forum-4.html) +--- Thread: HP-41 page 7 safety (/thread-6851.html) |
HP-41 page 7 safety - hth - 09-14-2016 05:21 AM Is it possible to make a module page 7 safe? That is, to make something else go to page 7 than the HP-IL. The Extended Functions/41CX it tests the presence of an HP-IL module in page 7 by calling location CHKCST (location 7CDD), but that is really testing the presence of a drive. I suspect other modules may use different approaches to check if the HP-IL module is present? Has anyone investigated this? RE: HP-41 page 7 safety - Ángel Martin - 09-15-2016 07:11 AM (09-14-2016 05:21 AM)hth Wrote: Is it possible to make a module page 7 safe? That is, to make something else go to page 7 than the HP-IL. The HEPAX would allocate itself to page-7 if available during its initialization, check its CALC_ON polling point code for details. It even goes to page-6 using the same routine. Obviously they must leave blank the hot areas, like the printer extended polling points. They also blanked the entry points to [IUNA] and [IUNALL]. I've done the same for the OS/X and PowerCL modules, which are meant to be both page-6 and page-7 safe... The HP-IL existence routine I added to the Library#4 checks for the word value at 7000, I thought this was better than the drive check HP used, and it's also compatible with other modules located there - like the HEPAX, the OS/X and the PowerCL. RE: HP-41 page 7 safety - hth - 09-16-2016 04:18 AM (09-15-2016 07:11 AM)Ángel Martin Wrote: The HEPAX would allocate itself to page-7 if available during its initialization, check its CALC_ON polling point code for details. It even goes to page-6 using the same routine. Obviously they must leave blank the hot areas, like the printer extended polling points. They also blanked the entry points to [IUNA] and [IUNALL]. I've done the same for the OS/X and PowerCL modules, which are meant to be both page-6 and page-7 safe... Where is the IUNA and IUNALL routines? I looked into the VASM listings for the HP-IL modules, but I could not find them. RE: HP-41 page 7 safety - Ángel Martin - 09-16-2016 05:50 AM (09-16-2016 04:18 AM)hth Wrote:(09-15-2016 07:11 AM)Ángel Martin Wrote: The HEPAX would allocate itself to page-7 if available during its initialization, check its CALC_ON polling point code for details. It even goes to page-6 using the same routine. Obviously they must leave blank the hot areas, like the printer extended polling points. They also blanked the entry points to [IUNA] and [IUNALL]. I've done the same for the OS/X and PowerCL modules, which are meant to be both page-6 and page-7 safe... sorry, I mispelled them: IAUNA is at 6DB2 IAUALL is at 6DB3 |