HP 91/92/97/97s printer spur (idler) gear - Printable Version +- HP Forums (https://www.hpmuseum.org/forum) +-- Forum: HP Calculators (and very old HP Computers) (/forum-3.html) +--- Forum: General Forum (/forum-4.html) +--- Thread: HP 91/92/97/97s printer spur (idler) gear (/thread-6015.html) Pages: 1 2 |
RE: HP 91/92/97/97s printer spur (idler) gear - aj04062 - 04-19-2016 11:55 PM I'm ready to order up a batch of 25 pcs. At this small of a production run the cost is much higher than 50, but I could still turn around them to everyone @ $25 each. Would everyone that might want one (or more) raise their hand? They are sweet gears: RE: HP 91/92/97/97s printer spur (idler) gear - Jlouis - 04-20-2016 12:47 AM one for me Thanks RE: HP 91/92/97/97s printer spur (idler) gear - PANAMATIK - 04-20-2016 01:42 AM One for me. Bernhard RE: HP 91/92/97/97s printer spur (idler) gear - Sadsilence - 04-20-2016 06:35 AM Raise hand for one, too. Thanks, Werner RE: HP 91/92/97/97s printer spur (idler) gear - Geoff Quickfall - 04-20-2016 08:33 AM 3 please RE: HP 91/92/97/97s printer spur (idler) gear - AndiGer - 04-22-2016 06:05 PM Just wondering ... two people from Germany raised hand ... If you follow Etienne Victoria's suggestion to order at GHW Modellbau - German only website. Use a sharp, new 2.3 mm drill bit (turned between your fingers (!) to widen the center hole - did that successfully) and you have an excellent brass substitute. The German guys could order some and send to the U.S. guys (or anywhere in the world) by normal letter @ 1.50 Euro postage each, 3-5 days delivery. Andi RE: HP 91/92/97/97s printer spur (idler) gear - Jlouis - 05-21-2016 10:05 PM Any news? |