03-09-2014, 04:16 PM
This may have been reported already: the AAngle modes are shown as:
0 - System (default)
1 - Degrees (Should be Radians)
2 - Radians (Should be Degrees)
Modes 1 and 2 are reversed from the actual modes.
To select a mode enter (either home or CAS view, or via ppl):
AAngle:=1, (The upper right icon will display angle mode for radians).
AAngle:=2, (The upper right icon will display angle mode for degrees).
-Dale-
0 - System (default)
1 - Degrees (Should be Radians)
2 - Radians (Should be Degrees)
Modes 1 and 2 are reversed from the actual modes.
To select a mode enter (either home or CAS view, or via ppl):
AAngle:=1, (The upper right icon will display angle mode for radians).
AAngle:=2, (The upper right icon will display angle mode for degrees).
-Dale-