HP Forums

Hello everyone, I know that it is a very general post, i'm sorry, but at least I will try to understand more about the HP25 calculator that was given to me by a friend of mine. So: when is ON and RUN, 0. appears on the right side of the display and pressing any button nothing happens. On PRGM it's 0, that's all.
Where should I start? Thank you all for your patience, and any replies.

Emanuele

Nice calculator!!

Maybe better to ask this on:
"HP Forums / HP calculators (and very old HP computers) / General Forum"
Success!

(01-16-2017 06:48 PM)Flayerty Wrote: [ -> ]Where should I start? Thank you all for your patience, and any replies.

This indicates most likely a defective ACT (Arithmetic Control Timing) chip. It can be repaired. See: this thread.

Bernhard

(01-17-2017 08:40 AM)Dirk.nl Wrote: [ -> ]Nice calculator!!

Maybe better to ask this on:
"HP Forums / HP calculators (and very old HP computers) / General Forum"
Success!

Thanks!

(01-17-2017 09:46 AM)PANAMATIK Wrote: [ -> ]

(01-16-2017 06:48 PM)Flayerty Wrote: [ -> ]Where should I start? Thank you all for your patience, and any replies.

This indicates most likely a defective ACT (Arithmetic Control Timing) chip. It can be repaired. See: this thread.

Bernhard

Thanks Bernard!