03-06-2015, 07:45 AM
Here's what I just did
Tired of trying to lookup the required Parameters and their order
by scrolling down and trying to find the Subroutine BEGIN.
Now I show them at the top of of the File in
Subroutine Declaration Area of Project File
Probably don't need the name after the //
but I did this in a Text Editor outside of CK as an afterthought.
Wished I'd done this from the start then I would have left out repeating the name.
Also, I try to keep it in alphabetical order.
I wish there was an easier way to navigate to a specific Subroutine in the Editor.
Like the way you can when you RUN a Subroutine.
Change Order Request??
Tired of trying to lookup the required Parameters and their order
by scrolling down and trying to find the Subroutine BEGIN.
Now I show them at the top of of the File in
Subroutine Declaration Area of Project File
Probably don't need the name after the //
but I did this in a Text Editor outside of CK as an afterthought.
Wished I'd done this from the start then I would have left out repeating the name.
Also, I try to keep it in alphabetical order.
I wish there was an easier way to navigate to a specific Subroutine in the Editor.
Like the way you can when you RUN a Subroutine.
Change Order Request??
Code:
INTAA(); // INTAA(P1,Az1,P2,Az2,P3)
INTAAX(); // INTAAX()
INTAD(); // INTAD(P1,Az1,P2,D2,P3)
INTADX(); // INTADX()
INTDA(); // INTDA(P1,D1,P2,Az2,P3)
INTDAX(); // INTDAX()
INTDD(); // INTDD(P1,D1,P2,D2,P3)
INTDDX(); // INTDDX()
INTFP(); // INTFP()
INTFPX(); // INTFPX()