10-09-2023, 04:50 PM
HP-Prime G2 firmware 2.1.14730 (2023 04 13)
CAS Mode.
CAS Settings, Simplify: Minimum
Screenshot #1.
No problem. Correct operation after pressing "Enter" or "Shift+Enter (≈)".
We repeat the command (screenshot no. 2), but first we set:
CAS Settings, Simplify: Maximum (screenshot no. 3).
After pressing "Enter" or "Shift+Enter ( ≈)", HP-Prime freezes (screenshot no. 4 - see upper right corner).
Now, if I press "On" after about 12 seconds, I will see the following text: "HP-Prime had a problem and will reboot in 3 secunds".
Could someone confirm this error? Maybe it's just my HP that does this?
[attachment=12634] [attachment=12635] [attachment=12636] [attachment=12637]
CAS Mode.
CAS Settings, Simplify: Minimum
Screenshot #1.
No problem. Correct operation after pressing "Enter" or "Shift+Enter (≈)".
We repeat the command (screenshot no. 2), but first we set:
CAS Settings, Simplify: Maximum (screenshot no. 3).
After pressing "Enter" or "Shift+Enter ( ≈)", HP-Prime freezes (screenshot no. 4 - see upper right corner).
Now, if I press "On" after about 12 seconds, I will see the following text: "HP-Prime had a problem and will reboot in 3 secunds".
Could someone confirm this error? Maybe it's just my HP that does this?
[attachment=12634] [attachment=12635] [attachment=12636] [attachment=12637]