09-19-2023, 12:52 PM
An excerpt from Horizontal-Axis Wind System rotor performance model comparison - a compendium, February 1983, Rockwell International
Table of Contents … {compendium} pg. 12 0f 564
…
Front Cover … {green book} pg. 32 of 564
…
Table of Contents … pg. 34 of 564
…
Executive Summary … pg. 38 of 564
This report covers the development of a prediction method (AERO) for horizontal axis turbines and the comparison of predictions with test data.
The prediction scheme is programmed both for Hewlett-Packard 41-C hand-held calculators and for digital computers using FORTRAN. Theory, listings and examples are given.
…
INTRODUCTION … pg. 41 of 564
The objective of this report is to provide a comparison between performance prediction and test results for horizontal axis wind turbines. This report covers the AERO program in two versions (FORTRAN and Hewlett-Packard 41-C) and the comparison between predicted and measured performance of the ENERTECH 1500 and UTRC 1/3 scale wind turbines.
…
APPENDIX B … pg. 71 of 564
AIRFOIL SECTION AERODYNAMICS
…
The following is the drag calculation sequence in the program. It begins at about line 600. … pg. 78 of 564
…
Program Listing … 798 steps, pgs. 86-88 of 564
…
BEST!
SlideRule
Table of Contents … {compendium} pg. 12 0f 564
…
Front Cover … {green book} pg. 32 of 564
…
Table of Contents … pg. 34 of 564
…
Executive Summary … pg. 38 of 564
This report covers the development of a prediction method (AERO) for horizontal axis turbines and the comparison of predictions with test data.
The prediction scheme is programmed both for Hewlett-Packard 41-C hand-held calculators and for digital computers using FORTRAN. Theory, listings and examples are given.
…
INTRODUCTION … pg. 41 of 564
The objective of this report is to provide a comparison between performance prediction and test results for horizontal axis wind turbines. This report covers the AERO program in two versions (FORTRAN and Hewlett-Packard 41-C) and the comparison between predicted and measured performance of the ENERTECH 1500 and UTRC 1/3 scale wind turbines.
…
APPENDIX B … pg. 71 of 564
AIRFOIL SECTION AERODYNAMICS
…
The following is the drag calculation sequence in the program. It begins at about line 600. … pg. 78 of 564
…
Program Listing … 798 steps, pgs. 86-88 of 564
…
BEST!
SlideRule