03-18-2023, 01:13 PM
I am very new to 41-series. Have been playing with programming a lot, but today I just did a simple loop that shows an increasing number, and don’t understand the behavior:
This shows X 1 though 8 or so quickly, then slows down to a crawl - about 2 seconds between showing the next number. Same behavior if I just switch the Alpha section to a simple VIEW X. If I don’t show the number, it is of course very fast (well, relatively speaking )
Could someone educate me on why that is happening?
Code:
LBL “TEST”
0.020
LBL 01
CLA
“X=“
ARCL X
AVIEW
ISG X
GTO 01
END
This shows X 1 though 8 or so quickly, then slows down to a crawl - about 2 seconds between showing the next number. Same behavior if I just switch the Alpha section to a simple VIEW X. If I don’t show the number, it is of course very fast (well, relatively speaking )
Could someone educate me on why that is happening?