HP Forums

Hi All,

I recently revised an HP-97 and before removing the card reader I took a few measurements and designed an install tool so that when I was going to re-assemble it would be in the right position.

Should you need something similar and have a 3D printer available please have a look here: https://www.thingiverse.com/thing:5153770/files

[attachment=10121]

Regards,
Bas

Thanks - this is super useful!

I'm printing one tonight.

Regards,

Dave

For those without a 3D printer, match marking the three screw positions on the base of the card reader with a paint marker and returning the reader to the same position works every time ;-)

Also, from what I have seen the screws leave an indent in the plastic so is easy to refit.

The tool is nice however.

cheers

Tony

Hi Dave,

Let me know if it works for you, so I can adjust the design if needed.

Regards,
Bas

(12-03-2021 11:33 PM)Dreato Wrote: [ -> ]Thanks - this is super useful!

I'm printing one tonight.

Regards,

Dave

Yes, that's what I should have done on the first HP-97 that I disassembled :-)

(12-04-2021 12:21 AM)GreyUser Wrote: [ -> ]For those without a 3D printer, match marking the three screw positions on the base of the card reader with a paint marker and returning the reader to the same position works every time ;-)