HP Forums

I just bought a Hand Held Products 32k EPROM 71B Module from eBay.
It is the bare board only, without the plastic parts.

Is anybody willing to send me a sketch or photo with dimensions of an actual module so that I can 3D print the plastic parts for mine?

Thanks!

The plastic for the HPP cases is very thin and stiff, and the fit around the module fairly tight, so I'm not sure if this lends itself to 3D printing.

If you'd like, I can ship you a case to more accurately measure and model the 2 case halves, assuming having one in-hand makes the job easier and more accurate.

Contact me off list to arrange that.

I would also be keen on making a cover as I recently purchased an eprom module. Probably from the same seller. Happy to assist in any way.

Cheer

Richard