02-14-2019, 02:39 AM
I was repairing my HP-41C and when I was closing it up, I noticed a small piece of foam on my workbench left over that very closely resembled the same material as the foot pads on the bottom of the calculator. I'm wondering if I wasn't paying attention and it fell out of the assembly somewhere when I had it open.
It's approximately 12.0 x 4.0 x 1.8 mm with some adhesive residue on one side.
Was it part of my 41C ? And if so, where does it go? The calculator functions normally as best as I can tell.
![[Image: foam-piece.jpg]](http://zener.com/tmp/foam-piece.jpg)
It's approximately 12.0 x 4.0 x 1.8 mm with some adhesive residue on one side.
Was it part of my 41C ? And if so, where does it go? The calculator functions normally as best as I can tell.