Post Reply 
HP67 Card read error
06-02-2017, 05:49 AM
Post: #1
HP67 Card read error
Just received a beautifully restored HP67 but have a problem reading clipped cards.
They all (including the standard pack cards) give an error. Unclipped cards write and read without any problems. Anyone a suggestion?

Regards
Qmat
Find all posts by this user
Quote this message in a reply
06-02-2017, 03:03 PM
Post: #2
RE: HP67 Card read error
(06-02-2017 05:49 AM)quaymat321234 Wrote:  Just received a beautifully restored HP67 but have a problem reading clipped cards.
They all (including the standard pack cards) give an error. Unclipped cards write and read without any problems. Anyone a suggestion?

Regards
Qmat

Perhaps the card reader motor has a slightly different speed than original and cannot read the prerecorded cards, but write and read new cards.

Bernhard

That's one small step for a man - one giant leap for mankind.
Find all posts by this user
Quote this message in a reply
06-02-2017, 04:22 PM (This post was last modified: 06-02-2017 04:52 PM by SlideRule.)
Post: #3
RE: HP67 Card read error
(06-02-2017 05:49 AM)quaymat321234 Wrote:  ... have a problem reading clipped cards. They all (including the standard pack cards) give an error. Unclipped cards write and read without any problems. Anyone a suggestion?
The old 65 Notes contained a novel approach to R/W a clipped magnetic card: a worn / used/ etc. magnetic card was trimmed on the right to MATCH the vertical profile on the left of the target clipped card. The trimmed card was then gently inserted in the card reader slot from the left and the clipped card was inserted from the right. I used this technique, it works! If you have access to the old Notes, the article is thorough and replete with illustrations, etc. If not, I'll elaborate in follow on dialog.
I also simply pinched a small piece of tape to the clipped corner with the same success. Both methods worked for me and should help you troubleshoot the clipped vs unclipped mystery.
BEST!
SlideRule

edit: found illustration, see attached png file
[attachment=4886]
Find all posts by this user
Quote this message in a reply
06-02-2017, 04:41 PM
Post: #4
RE: HP67 Card read error
(06-02-2017 03:03 PM)PANAMATIK Wrote:  Perhaps the card reader motor has a slightly different speed than original and cannot read the prerecorded cards, but write and read new cards.

Bernhard

That's an interesting hypothesis. If you have a card to spare, perhaps you can clip one that is currently reading OK and see if it still reads correctly?

If so, as Bernhard notes, perhaps it's an issue of "old recording" vs. "new recording" rather than "clipped" vs. "not clipped."
Find all posts by this user
Quote this message in a reply
06-08-2017, 03:07 PM
Post: #5
RE: HP67 Card read error
If a clipped card reader problem (and since it is restored), it would appear maybe the clipped card detector spring, one of the 5 finger springs under the card reader assembly is bent, or the ball that is pressed down to engage the detector spring is missing.

You never know how 'restored' a card reader is!
Find all posts by this user
Quote this message in a reply
Post Reply 




User(s) browsing this thread: 1 Guest(s)