Post Reply 
HP41CX Catalog 2 does not work
03-01-2015, 05:47 AM
Post: #1
HP41CX Catalog 2 does not work
I bought a HP41CX calculator from e-bay. I fixed it because the rechargeable battery pack corroded inside the calculator and corroded the terminals also.

I cleaned inside and changed the terminals.

I have 4 application modules installed in the calculator.

The HP41CX executes the programs from the modules but does not show these in the Catalog 2.

The Catalog 2 only shows 7 programs included some from HP41CX.

Any ideas?

Edwin

Edwin
Find all posts by this user
Quote this message in a reply
03-01-2015, 06:01 AM
Post: #2
RE: HP41CX Catalog 2 does not work
The cx shows the major sections of the modules, and then to see what's in a section, you stop the listing and press Enter, and it will show the individual functions and programs in that section. I understand the c and cv did not do it this way.

http://WilsonMinesCo.com (Lots of HP-41 links at the bottom of the links page, http://wilsonminesco.com/links.html )
Visit this user's website Find all posts by this user
Quote this message in a reply
03-01-2015, 07:04 AM
Post: #3
RE: HP41CX Catalog 2 does not work
Garth Hello,

You are right. It's different from HP41C and CV.

Cat 2, R/S, Enter and list all the functions.

Thank you very much. My HP41CX works fine.

Edwin
Find all posts by this user
Quote this message in a reply
Post Reply 




User(s) browsing this thread: 1 Guest(s)