HP-71 Compu-LS module

[rprosperi]

(03-21-2017 02:23 PM)twa14 Wrote:  When I hit restore io in EMU71/win I get "stmt not found". When I hit PLIST COMPU emu71 starts printing off the basic but I get nothing in the ILper screen?

I thought you were doing this is in an actual '71 machine. Have you configured EMU71/Win to connect to IL-Per via TCP/IP?

If you don't have EMU71 and ILPer connected yet, you will need to read in the EMU71/Win manual how to configure HP-IL to communicate via virtual HP-IL over TCP/IP. It sounds complex, but is actually pretty straightforward. You will need to configure both EMU71 and IL-Per. Configure the addresses such that each side is sending TO the same address the other is receiving FROM.

Example: On EMU71, set the HP-IL Interface setup as follows:

Out TCP/IP Address: localhost
Out Port: 60001
In Port: 60000

And on IL-Per, after changing the COM port to TCP/IP, set the HP-IL Interface setup as follows:

Out TCP/IP Address: localhost
Out Port: 60000
In Port: 60001

After saving settings, launch IL-Per, click start to enable it, then launch EMU71 and use RESTORE IO to configure the HP-IL loop.