HP-71 Compu-LS module
|
03-20-2017, 03:09 PM
Post: #39
|
|||
|
|||
RE: HP-71 Compu-LS module
Hi Tom,
(03-20-2017 01:14 PM)rprosperi Wrote:(03-20-2017 12:39 PM)twa14 Wrote: Thanks Christoph, almost there. I managed to install POKELEX and run ROMDMP. It ran in ILper for about 35 minutes and seemed to be ok but I can't find the output file? The module is called "COMPU" and when I check the cat it is listed as "COMPU P BASIC 32632" followed by "KEYWAIT LEX 55" . On the basis of this I changed the name on your ROMDMP Basic program from "JPCF05" to "COMPU" and ran the program. No error messages this time, so where could the output file be? Note that the binary image of the ROM can be loaded into Emu71/Win using the Port Configuration menu. However, to be able to ROMCOPY the image into an IRAM will require copying the file to a LIF disc image, which is not an obvious task. Refer to [FRAM71] Pre-Production Batch, Post #2, http://www.hpmuseum.org/forum/thread-251...l#pid22721 for one technique of doing so. Speaking of FRAM71, if you find the 71B fun, consider obtaining a FRAM71 module. Some latecomers were still able to purchase a module from the last batch. http://www.hpmuseum.org/forum/thread-5437.html Dave |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 5 Guest(s)