Hide soft menus?

[DavidM]

(01-27-2017 08:03 AM)JDW Wrote:  Sorry for my testing delay, but I didn't have time until today.

The same applies to me.

(01-27-2017 08:03 AM)JDW Wrote:  I installed your Version 2.11 beta into ...
...Port 0...
...Port 1...
...Port 2...

I would encourage the rest of you following this thread to try the same on your own 50g's.

I tried the same 2.11 beta on a "totally empty" v2.15 50g -- there were no objects other than the messages library installed in any port (not even periodic table or eqn lib), and ON-A-F was performed to clear all standard memory. The only change from factory reset was to change to RPN mode.

My results were exactly the same as James'. The library appeared to work properly from Port 0, but would not install itself successfully on warmstart from Port 1 or 2.

Andreas: is version 2.11 the correct one for testing from covered ports? That's the latest one I saw posted in this thread.