WP 34S: CASE example issue in the latest manual
|
03-09-2016, 11:50 PM
(This post was last modified: 03-09-2016 11:55 PM by Dieter.)
Post: #2
|
|||
|
|||
RE: WP 34S: CASE example issue in the latest manual
(03-08-2016 11:23 PM)Didier Lachieze Wrote: I've found an issue in the example of the CASE instruction in my pdf manual v3.3 compared to my 34S v3.3 rev 3815: FTR: the same error can be found in the freely available v3.2 PDF manual (and I assume it's also in other, earlier versions). In the given example all references to the content of r12 are off by one. On the other hand the initial general description of the CASE function is correct: "CASE s ... works like SKIP below but takes the number of steps to skip from s". The following example, however, is wrong, just as you said. Walter: if you prepare a correction you should also add that negative arguments (e.g. "r12≤0") are not allowed and will throw an "Out or Range" error. Dieter |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)