Post Reply 
RPN Scientific Firmware for the Spikenzielabs Calculator Kit
04-02-2016, 04:23 PM
Post: #13
RE: RPN Scientific Firmware for the Spikenzielabs Calculator Kit
Hi Dave,

I just used a single header strip, and cut off a section of 6 pins with a pair of wire cutters. It is not a right-angle header -- just a straight pin header. I don't know whether a right angle header would fit in the small space. I then laid the header on the back of the board to align with the six pads and tack soldered it in place. Here is the strip I cut a six pin section off of, and the section soldered in place (photos attached).

Good luck with the kit!

Steve.


Attached File(s) Thumbnail(s)
       
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: RPN Scientific Firmware for the Spikenzielabs Calculator Kit - securd - 04-02-2016 04:23 PM



User(s) browsing this thread: 1 Guest(s)