[wp34s] Permanently damaged machines when flashing
|
07-25-2015, 07:29 AM
Post: #3
|
|||
|
|||
RE: [wp34s] Permanently damaged machines when flashing
It is also possible that the input protection diodes went into "Latch Up" when the TX voltage went .5V above
the power supply voltage. To clear the "Latch Up" state remove the batteries and short the 3V and GND terminals of the battery for a few seconds to drain any power supply capacitors. Then reinstall the batteries to see if the calculator wakes up again. If you had left the calculator in the "Latch Up" state for any length of time it is likely that the batteries suffered a significant drain, and it might be wise to start with a fresh set of batteries after the battery-removal / Discharge procedure. Good Luck, Barry |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
[wp34s] Permanently damaged machines when flashing - emece67 - 07-24-2015, 10:49 PM
RE: [wp34s] Permanently damaged machines when flashing - Perre52 - 07-25-2015, 06:47 AM
RE: [wp34s] Permanently damaged machines when flashing - BarryMead - 07-25-2015 07:29 AM
RE: [wp34s] Permanently damaged machines when flashing - Perre52 - 07-26-2015, 05:06 AM
RE: [wp34s] Permanently damaged machines when flashing - lcwright1964 - 07-26-2015, 01:29 AM
RE: [wp34s] Permanently damaged machines when flashing - dewster - 10-15-2015, 04:54 PM
|
User(s) browsing this thread: 1 Guest(s)