HP Forums / HP Calculators (and very old HP Computers) / General Forum v / Soldering Station/Iron recommendation....

Post Reply 
Soldering Station/Iron recommendation....
07-21-2015, 05:12 PM (This post was last modified: 07-21-2015 05:21 PM by Dave Frederickson.)
Post: #16
Dave Frederickson Offline
Senior Member
 		Posts: 2,189
Joined: Dec 2013
RE: Soldering Station/Iron recommendation....
(07-21-2015 04:58 PM)eried Wrote:  I have no complains in 3 years since I got this one:

http://www.ebay.com/itm/New-ATTEN-AT8586...3f49f402b6

That's pretty nice, Erwin. It looks like it'll work for heat shrink tubing and lifting labels, too.

$150 on Amazon in the U.S.

Frying pans have also been used for reflowing surface mount parts, but that's a little out of my comfort zone, although I suggest a good non-stick surface. Smile

Dave
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Soldering Station/Iron recommendation.... - Dave Frederickson - 07-21-2015 05:12 PM



User(s) browsing this thread: 1 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication