Animated Graphs

[jebem]

(09-13-2014 07:37 PM)Thomas Ritschel Wrote:  

(09-13-2014 11:38 AM)Marcus von Cube Wrote:  I tried your example. It caused the calculator to hang on the first attempt and to reboot on the second. I don't think this can easily be reproduced because it is highly interactive.

My Prime also hanged on the first attempt. This was the very first time that I used the "Geometry" App. I had similar crashes (freezing UI) when I tried some of the other Apps for the first time, e.g. "Advanced Graphing", "Spreadsheet", "Parametric" and maybe also the statistics Apps.

Perhaps the Apps are not properly initialized...?

The same happens with my Prime (h/w Rev A and f/w 6030).

The animation works fine using the example indicated by Cyrille in post #3 and #7.

But after trying to play with it by editing the animation step value, changing it from the default 0.1 to 0.05, it crashes and a few moments later it came up with the (x2 + y2 =1) display, but after that it went to a power off state.
The On key did not answer.
I had to do a hard reset with a paper clip in the back to recover, and lost the previous memory state contents, as expected.