HP41 CL Board installation
|
11-27-2017, 03:47 AM
Post: #12
|
|||
|
|||
RE: HP41 CL Board installation
See below a description of how to hold the motherboard without nuts
The idea is a system similar to the little cups found in later HP-41C models I used two nylon flange bearings (Hillman NFB-1025U H# 415599) bought at a major home improvement store. It was necessary to shorten them to about 2.5 mm thickness (rough cut with electrical wire cutting pliers, finish with sandpaper) That's it - see attached pictures |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
HP41 CL Board installation - Neve - 11-11-2017, 09:37 PM
RE: HP41 CL Board installation - Monte Dalrymple - 11-11-2017, 09:51 PM
RE: HP41 CL Board installation - Neve - 11-11-2017, 10:18 PM
RE: HP41 CL Board installation - David Hayden - 11-13-2017, 05:51 PM
RE: HP41 CL Board installation - HP-Collection - 11-13-2017, 06:18 PM
RE: HP41 CL Board installation - rprosperi - 11-13-2017, 06:30 PM
RE: HP41 CL Board installation - Neve - 11-13-2017, 06:37 PM
RE: HP41 CL Board installation - Sylvain Cote - 11-13-2017, 07:54 PM
RE: HP41 CL Board installation - Benoit Maag - 11-15-2017, 08:07 AM
RE: HP41 CL Board installation - Neve - 11-15-2017, 08:24 AM
RE: HP41 CL Board installation - Massimo Gnerucci - 11-15-2017, 09:16 AM
RE: HP41 CL Board installation - Benoit Maag - 11-27-2017 03:47 AM
|
User(s) browsing this thread: 1 Guest(s)