HP41 CL Board installation

[Neve]

Hi,

I received my V5 board. Everything is fine and works. Thanks Monte.

I just have question not specifically related to this board itself or to the update process in particular, but rather regarding the serial connector.
For mechanical reasons which are not relevant, I had to desolder the 2.5 jack to install it. I took a picture of the wires before I did. But as it turns out, the picture is blurry.
Can anyone tell me where the wires need to be connected? I can’t see anything... Ooops.
Also, the wires press outward on the spacer between the 2 halves. Hmmmm.

FYI, I have an older Tallkey version with nuts holding down the board. I removed them and screwed them back on very easily.