Saving calculator state to free memory on CL V5
|
11-06-2017, 12:43 PM
Post: #4
|
|||
|
|||
RE: Saving calculator state to free memory on CL V5
Hello Geoff,
(11-06-2017 06:58 AM)Geoff Quickfall Wrote: Merci Sylvain!De rien. Sorry for my teasing mood answer yesterday, I had too much excellent wine and I should never post in that mode. (11-06-2017 06:58 AM)Geoff Quickfall Wrote: I won't update the version five that I just received, until both you and Monte post. I will be updating my version two once I make the cable tomorrow.Be aware that beta and v2 boards are the same hardware and treated as such. If you update your beta board you will loose your backup at 0C9. Please do not update your CLv5 until a new version of clupdate is released. I have not yet tested it, but I am pretty sure it will sees it as a 41CLv4 board. (11-06-2017 06:58 AM)Geoff Quickfall Wrote: I was reading power CL manual and the ywall seems to be similar to my coding above. Is it compatible with ver5 and version 2?It has been a while that I have used the Power CL module, I will check tonight and get back to you when I have the answer. Best regards, Sylvain |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
Saving calculator state to free memory on CL V5 - Geoff Quickfall - 11-05-2017, 07:52 PM
RE: Saving calculator state to free memory on CL V5 - Sylvain Cote - 11-05-2017, 09:19 PM
RE: Saving calculator state to free memory on CL V5 - Geoff Quickfall - 11-06-2017, 06:58 AM
RE: Saving calculator state to free memory on CL V5 - Sylvain Cote - 11-06-2017 12:43 PM
RE: Saving calculator state to free memory on CL V5 - Geoff Quickfall - 11-06-2017, 05:03 PM
|
User(s) browsing this thread: 1 Guest(s)