Post Reply 
List API (G1CMZ): List Processing API
10-03-2018, 01:43 PM (This post was last modified: 10-28-2018 11:51 PM by John Keith.)
Post: #20
RE: List API (G1CMZ): List Processing API
(10-03-2018 07:04 AM)StephenG1CMZ Wrote:  Would it help if instead of prefixing the names with "List", some other prefix were used?
Like Z perhaps, thus placing it near the end of the catalogue (only 4 other names, plus some symbols), or Y (no other names in the catalogue)?
Or would it still be inconvenient there?

I'm not sure what the best solution is. The problem as I see it is that the Prime's catalog has a huge number of commands, most of which are not in the toolbox menus. This forces one to either type command names in or search through the catalog for them.

This issue is compounded by each app adding its own commands to the catalog as well. I think that the best approach is to minimize the number of new commands and hope that the fine folks at HP can come up with a way to better organize the catalog and toolbox.

John
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: List API (G1CMZ): List Processing API - John Keith - 10-03-2018 01:43 PM



User(s) browsing this thread: 1 Guest(s)