Post Reply 
a degree radians question....
10-20-2017, 11:19 PM
Post: #1
a degree radians question....
if i type 1<angle>30_deg, and my default angles are in radians, when I hit enter, it comes out as 1<angle>0.5325, converting to radians.
However, if in the geometry app, I enter point(1<angle>30_deg), it can't deal with it, whereas point(1<angle>0.5235) works fine.

Is there a fast way to convert from 1<angle>30_deg to radians (like enter does)....so it can be used in the point call?

I know I can cut and paste from the enter conversion....but I'm wondering why the point function doesn't understand the units and if there is an easier way to enter it as degrees when the default angle format is radians????????????

Thanks
-D
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
a degree radians question.... - webmasterpdx - 10-20-2017 11:19 PM
RE: a degree radians question.... - Anders - 10-23-2017, 03:39 PM
RE: a degree radians question.... - Anders - 10-23-2017, 10:07 PM
RE: a degree radians question.... - Anders - 10-23-2017, 10:44 PM



User(s) browsing this thread: 2 Guest(s)