[WP34S] New GUI features

[pascal_meheut]

(01-23-2016 10:18 AM)fhub Wrote:  Well, without '-op ...' option the assembler uses the file 'wp34s.op' in the same folder where the assembler is located by default. To use any other op-file you have to use this option '-op' (with the full pathname of this op-file).

Ok. There is already an option to choose the "tools" directory. Isn't it enough?

If not, I'll look into a quick solution (i.e. an op file location option and/or an assembler command option) as I cannot spend too much time on the emulators at the moment.