DM-15L current draw problem
|
12-28-2015, 06:35 PM
(This post was last modified: 12-28-2015 11:10 PM by Katie Wasserman.)
Post: #1
|
|||
|
|||
DM-15L current draw problem
I have a DM-15L board -- the one with the bad buttons -- and decided to measure the current draw on it. It's quite low except when a button is held down, then it's 10mA. But even worse is that it's still 10mA when the calculator is turned off! So if you have a button that is being pressed down when the calculator is in a bag, pocket, whatever, you'll deplete the CR2032 in short order.
Can someone confirm if the newer boards have the same high current draw when a key is held down. -katie |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
DM-15L current draw problem - Katie Wasserman - 12-28-2015 06:35 PM
RE: DM-15L current draw problem - BruceH - 12-30-2015, 01:27 AM
RE: DM-15L current draw problem - Harald - 12-30-2015, 06:06 PM
RE: DM-15L current draw problem - matthiaspaul - 12-30-2015, 06:37 PM
RE: DM-15L current draw problem - Sadsilence - 12-30-2015, 07:57 PM
RE: DM-15L current draw problem - Bernd Grubert - 02-04-2016, 09:10 PM
RE: DM-15L current draw problem - Steve Simpkin - 02-05-2016, 12:58 AM
RE: DM-15L current draw problem - Bernd Grubert - 02-05-2016, 07:48 AM
RE: DM-15L current draw problem - Steve Simpkin - 02-05-2016, 09:27 AM
RE: DM-15L current draw problem - Katie Wasserman - 02-05-2016, 07:42 AM
RE: DM-15L current draw problem - Bernd Grubert - 02-05-2016, 07:51 AM
RE: DM-15L current draw problem - Bernd Grubert - 02-05-2016, 08:29 PM
|
User(s) browsing this thread: 1 Guest(s)