Soldering Station/Iron recommendation....
|
07-21-2015, 08:41 AM
(This post was last modified: 07-21-2015 08:43 AM by BartDB.)
Post: #13
|
|||
|
|||
RE: Soldering Station/Iron recommendation....
(07-21-2015 03:50 AM)Dave Frederickson Wrote: Vacuum de-soldering tools, like a squeeze bulb or Soldapullt are preferable to solder braid, especially with through-hole components. My vote is vice-versa, preferring de-soldering braid to a solder-sucker, especially on older printed boards I have found the pads being sucked off (particularly with single layer boards where the pad is not held in place by through-hole plating). Pre-wetting the braid with a liquid flux helps absorbtion of the solder. -Bart |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 2 Guest(s)