Practical question for mechanical/Civil engineers

Threaded Mode | Linear Mode

Practical question for mechanical/Civil engineers

05-19-2015, 05:12 AM

Post: #4

cyrille de brébisson Offline

Senior Member

Posts: 1,047
Joined: Dec 2013

RE: Practical question for mechanical/Civil engineers

Hello,

Thanks a lot guys, I will keep you posted on the 'pour' which, if all goes well should happen this WE.
I have decided to hold the board in 3 points using 3 threaded rods and do the pour in 2 passes (bottom and then top)... to reduce pressure on my board.

Cyrille

« Next Oldest | Next Newest »

Messages In This Thread

Practical question for mechanical/Civil engineers - cyrille de brébisson - 05-18-2015, 05:37 AM

RE: Practical question for mechanical/Civil engineers - CR Haeger - 05-18-2015, 01:21 PM

RE: Practical question for mechanical/Civil engineers - Alex Mark - 05-18-2015, 03:57 PM

RE: Practical question for mechanical/Civil engineers - cyrille de brébisson - 05-19-2015 05:12 AM

RE: Practical question for mechanical/Civil engineers - Paul Dale - 05-19-2015, 06:09 AM

RE: Practical question for mechanical/Civil engineers - Claudio L. - 05-19-2015, 01:22 PM

RE: Practical question for mechanical/Civil engineers - Claudio L. - 05-19-2015, 01:45 PM

RE: Practical question for mechanical/Civil engineers - Claudio L. - 05-19-2015, 02:58 PM

RE: Practical question for mechanical/Civil engineers - BruceH - 05-22-2015, 12:15 AM

RE: Practical question for mechanical/Civil engineers - TASP - 05-19-2015, 03:17 PM

RE: Practical question for mechanical/Civil engineers - cyrille de brébisson - 05-22-2015, 05:24 AM

User(s) browsing this thread: 1 Guest(s)