HP67 black cable broken
|
02-26-2015, 12:37 AM
(This post was last modified: 02-26-2015 12:39 AM by Geoff Quickfall.)
Post: #4
|
|||
|
|||
RE: HP67 black cable broken
Yes! Under a magnifier you should see part of the remaining black wire in the centre. So vacuum up the solder with a de solder bulb or braid.
Then retin and solder when ready. I actually de solder these prior to restoration so that I can clean the keyboard separately from the framework housing. Cheers, Geoff Another trick, if the solder points at the receptacle end need new wiring, plug the charger/wall wart into the calc but not the wall! This will hold the pins in place when you heat the solder. |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
HP67 black cable broken - Uli - 02-25-2015, 09:04 PM
RE: HP67 black cable broken - Geoff Quickfall - 02-25-2015, 09:17 PM
RE: HP67 black cable broken - Uli - 02-25-2015, 09:23 PM
RE: HP67 black cable broken - Geoff Quickfall - 02-26-2015 12:37 AM
|
User(s) browsing this thread: 1 Guest(s)