WP34S in less than 3 hours
|
04-26-2015, 11:57 PM
Post: #9
|
|||
|
|||
RE: WP34S in less than 3 hours
As a guide when checking if the solderings went right, here are some points one can use to check continuity.
The ERASE pin soldering can be tested with a multimeter whose + terminal is connected to ERASE and the - terminal to GND. The meter should read around 15 kOhm. Hope this helps. Regards. |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
WP34S in less than 3 hours - PANAMATIK - 11-02-2014, 09:46 AM
RE: WP34S in less than 3 hours - Marcus von Cube - 11-02-2014, 11:02 AM
RE: WP34S in less than 3 hours - PANAMATIK - 11-02-2014, 07:52 PM
RE: WP34S in less than 3 hours - Michael Kathke - 04-17-2015, 01:13 PM
RE: WP34S in less than 3 hours - walter b - 04-17-2015, 01:57 PM
RE: WP34S in less than 3 hours - Michael Kathke - 04-17-2015, 04:54 PM
RE: WP34S in less than 3 hours - PANAMATIK - 04-17-2015, 05:34 PM
RE: WP34S in less than 3 hours - emece67 - 04-23-2015, 12:21 PM
RE: WP34S in less than 3 hours - emece67 - 04-26-2015 11:57 PM
|
User(s) browsing this thread: 1 Guest(s)