Mulling over a potential Pioneer key repair approach
|
09-03-2014, 11:39 PM
(This post was last modified: 09-03-2014 11:40 PM by Katie Wasserman.)
Post: #3
|
|||
|
|||
RE: Mulling over a potential Pioneer key repair approach
I've never tried that but I can't imagine that it would work. The entire hinged key section is a single molded piece that offers no obvious way to section it without it falling apart.
I think you have a much better chance of trying to fix the few keys that are broken by melting into the remaining plastic a small, thin, flexible piece of metal to serve as the hinge. -katie |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
Mulling over a potential Pioneer key repair approach - Dave Britten - 09-03-2014, 05:21 PM
RE: Mulling over a potential Pioneer key repair approach - Dave Britten - 09-03-2014, 11:31 PM
RE: Mulling over a potential Pioneer key repair approach - Katie Wasserman - 09-03-2014 11:39 PM
RE: Mulling over a potential Pioneer key repair approach - aj04062 - 09-04-2014, 01:10 AM
RE: Mulling over a potential Pioneer key repair approach - Geoff Quickfall - 09-04-2014, 04:16 AM
RE: Mulling over a potential Pioneer key repair approach - Dave Britten - 09-04-2014, 10:41 AM
RE: Mulling over a potential Pioneer key repair approach - everettr - 09-04-2014, 03:56 PM
RE: Mulling over a potential Pioneer key repair approach - Geoff Quickfall - 09-04-2014, 04:17 PM
RE: Mulling over a potential Pioneer key repair approach - Dave Britten - 09-04-2014, 04:20 PM
|
User(s) browsing this thread: 1 Guest(s)