Search
Member List
Calendar
Help
|
Problem with my 11c
|
|
12-22-2013, 06:28 PM
(This post was last modified: 12-22-2013 06:31 PM by Geoff Quickfall.)
Post: #6
|
|||
|
|||
|
RE: Problem with my 11c
Just read your answer! As I said above, check out the IC's solder points. Obviously no need to introduce the DeOxit through the pin holes since you have access to the opposite side. It sounds like the IC is not getting the signal from the 'on' position but only the 'off' and yet for some reason any other key does send an 'on' logic to the IC.
Geoff |
|||
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Problem with my 11c - hayesbd - 12-22-2013, 01:36 PM
RE: Problem with my 11c - Katie Wasserman - 12-22-2013, 04:46 PM
RE: Problem with my 11c - Geoff Quickfall - 12-22-2013, 06:05 PM
RE: Problem with my 11c - hayesbd - 12-22-2013, 06:20 PM
RE: Problem with my 11c - Geoff Quickfall - 12-22-2013, 06:24 PM
RE: Problem with my 11c - Geoff Quickfall - 12-22-2013 06:28 PM
RE: Problem with my 11c - hayesbd - 12-22-2013, 07:14 PM
RE: Problem with my 11c - hayesbd - 12-22-2013, 07:25 PM
RE: Problem with my 11c - Geoff Quickfall - 12-22-2013, 07:43 PM
RE: Problem with my 11c - Ed Wright - 12-26-2013, 08:22 PM
RE: Problem with my 11c - Geoff Quickfall - 12-26-2013, 08:26 PM
RE: Problem with my 11c - Thomas Radtke - 12-26-2013, 09:24 PM
RE: Problem with my 11c - Geoff Quickfall - 12-26-2013, 09:26 PM
|
User(s) browsing this thread: 1 Guest(s)