3D Printed Sting 10 / 19C Battery Tray
|
02-01-2022, 01:20 PM
Post: #8
|
|||
|
|||
RE: 3D Printed Sting 10 / 19C Battery Tray
(02-01-2022 08:56 AM)Jonas Sandstedt Wrote: Furthermore, modern AA cells are slightly larger than the older ones, and therefore I think it is difficult to fit them properly in the original battery holders that can’t be re-assembled properly, and the battery cover is therefore sometimes hard to close. Dispensing with the need for a battery holder makes this handling easier as well. If you will use AA cells, you should only use flat-top cells, not the normal grocery-store AA type with button tops. The original cases, and the intended spring/contact solution was designed for, and only operates properly with the flat-top types; as Jonas alludes to here, the common variety are too tall, don't fit the cases, and can cause removal problems and even damage. Include "flat-top" when you search for cells, they are easy to find online. --Bob Prosperi |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
3D Printed Sting 10 / 19C Battery Tray - aj04062 - 01-26-2022, 12:03 AM
RE: 3D Printed Spice 10 / 19C Battery Tray - Harald - 01-26-2022, 10:53 AM
RE: 3D Printed Spice 10 / 19C Battery Tray - aj04062 - 01-27-2022, 02:06 AM
RE: 3D Printed Sting 10 / 19C Battery Tray - dmh - 01-27-2022, 06:16 AM
RE: 3D Printed Sting 10 / 19C Battery Tray - Jonas Sandstedt - 01-27-2022, 08:05 AM
RE: 3D Printed Sting 10 / 19C Battery Tray - dmh - 01-31-2022, 11:11 AM
RE: 3D Printed Sting 10 / 19C Battery Tray - Jonas Sandstedt - 02-01-2022, 08:56 AM
RE: 3D Printed Sting 10 / 19C Battery Tray - rprosperi - 02-01-2022 01:20 PM
|
User(s) browsing this thread: 1 Guest(s)