HP Forums / HP Calculators (and very old HP Computers) / General Forum v / 41CL and Mac Mojave - USB-to-serial device no longer in /dev

Post Reply 
41CL and Mac Mojave - USB-to-serial device no longer in /dev
01-06-2019, 05:17 AM (This post was last modified: 01-06-2019 05:20 AM by rprosperi.)
Post: #10
rprosperi Offline
Super Moderator
 		Posts: 6,194
Joined: Dec 2013
RE: 41CL and Mac Mojave - USB-to-serial device no longer in /dev
(01-05-2019 06:26 PM)smp Wrote:  I went back and executed the OSUPDT command and then executed the FLUPD command again, and the process went ahead and successfully completed. Whew!

smp

Once the OS is succesfuly updated, you should use the OSPROT command to restore the default state of OS protection. In any case, this is restored upon every power-on, so it's probably already taken care of on you machine, just mentioning it to be complete for future readers.

And now that you're fully updated, do another scan after setting CPONLY, just to see it. It's worth it to see a full scan complete in about 1.5 minutes. Smile
--Bob Prosperi
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: 41CL and Mac Mojave - USB-to-serial device no longer in /dev - rprosperi - 01-06-2019 05:17 AM



User(s) browsing this thread: 1 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication