Post Reply 
How to evaluate A Taylor series at a specific value
08-21-2018, 04:47 PM (This post was last modified: 08-21-2018 04:48 PM by parisse.)
Post: #16
RE: How to evaluate A Taylor series at a specific value
But a Taylor expansion has two parts: the polynomial part and the remainder term. Unfortunately students tend to forget the remainder term, and that will not help if the calculator ignores it as well. That's why you have taylor(.) and taylor(.,polynom) on the HP. And if you don't remind the polynom trick, you can still run f:=taylor(sin(x),x=0,5) then f|x=0.5 and ignore the order_size term.
:-)
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: How to evaluate A Taylor series at a specific value - parisse - 08-21-2018 04:47 PM



User(s) browsing this thread: