DM15 firmware update failureS
|
02-18-2018, 05:05 AM
(This post was last modified: 02-18-2018 08:09 PM by sjthomas.)
Post: #1
|
|||
|
|||
DM15 firmware update failureS
[Ignore -- All the firmware flashing mucking about I was doing caused the battery in both units to go completely flat. Re-replacing them did the trick. D'OH!]
Hello All, I have two DM-15’s which I was attempting to update the firmware. I tried one using Windows 7, and the other using Mac High Sierra. Unfortunately, I have run into the same problem with both: The flash process starts, but after 7 lines, errors with the message “Program Too Large — running out of flash sectors.” And although the instructions on the website say “it is not possible to break or brick the calculator,” it seems that is what has happened. I can not get either unit to do anything, not even power on. Batteries are fresh. All drivers installed on the computers without issue. Using a good quality shielded miniUSB cable. Would appreciate any helpful suggestions. sjt |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
DM15 firmware update failureS - sjthomas - 02-18-2018 05:05 AM
RE: DM15 firmware update failureS - Nigel (UK) - 02-18-2018, 08:57 AM
|
User(s) browsing this thread: 1 Guest(s)