Bad HP41 display? Shows @'s and whistles
|
03-13-2017, 04:26 PM
Post: #10
|
|||
|
|||
RE: Bad HP41 display? Shows @'s and whistles
Hi Ignacio,
Self-leveling just refers to the medium viscosity of the material. It will flow to fill cracks or holes for cosmetic purposes, but to get a strong bond, you need to coat both surfaces you want to join, and then clamp them together for a few hours. If the broken piece is just pressed into place, the bonded joint will fail under pressure. With a finger-tight clamping force though, the joint seems nearly as good as new. I think you can get the mini tube pack or smaller precision tip pack with the same formula. Hope it works for you as well. I'll post a separate progress report message about the flex replacement in a few days when I have all the materials needed. Consider yourself first on the field trial list ~ Mark Remember kids, "In a democracy, you get the government you deserve." |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
Bad HP41 display? Shows @'s and whistles - mfleming - 03-09-2017, 10:13 PM
RE: Bad HP41 display? Shows @'s and whistles - isanchez - 03-10-2017, 07:51 AM
RE: Bad HP41 display? Shows @'s and whistles - Geoff Quickfall - 03-10-2017, 05:15 PM
RE: Bad HP41 display? Shows @'s and whistles - AndiGer - 03-10-2017, 06:22 PM
RE: Bad HP41 display? Shows @'s and whistles - mfleming - 03-10-2017, 11:51 PM
RE: Bad HP41 display? Shows @'s and whistles - Hans Brueggemann - 03-13-2017, 11:02 AM
RE: Bad HP41 display? Shows @'s and whistles - mfleming - 03-13-2017, 02:28 PM
RE: Bad HP41 display? Shows @'s and whistles - isanchez - 03-13-2017, 09:02 AM
RE: Bad HP41 display? Shows @'s and whistles - isanchez - 03-13-2017, 03:33 PM
RE: Bad HP41 display? Shows @'s and whistles - mfleming - 03-13-2017 04:26 PM
RE: Bad HP41 display? Shows @'s and whistles - isanchez - 03-13-2017, 04:54 PM
|
User(s) browsing this thread: 1 Guest(s)