[WP 34s] Trapezoidal approximation of area under curve
|
06-16-2015, 10:47 AM
(This post was last modified: 06-16-2015 10:49 AM by Marcio.)
Post: #7
|
|||
|
|||
RE: [WP 34s] Trapezoidal approximation of area under curve
Hello again,
Does anyone know how to do \(RCL+ Z\) on the 35s? From what I saw in the manual, one has to use the EQN inside the program in order to recall the \(z\)-register, which is somewhat dangerous. Thanks. |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
[WP 34s] Trapezoidal approximation of area under curve - Marcio - 06-01-2015, 01:53 PM
RE: [WP 34s] Trapezoidal approximation of area under curve - Marcus von Cube - 06-01-2015, 03:54 PM
RE: [WP 34s] Trapezoidal approximation of area under curve - Dave Britten - 06-01-2015, 05:36 PM
RE: [WP 34s] Trapezoidal approximation of area under curve - Thomas Klemm - 06-01-2015, 06:56 PM
RE: [WP 34s] Trapezoidal approximation of area under curve - Dieter - 06-02-2015, 09:23 PM
RE: [WP 34s] Trapezoidal approximation of area under curve - Marcio - 06-02-2015, 02:46 AM
RE: [WP 34s] Trapezoidal approximation of area under curve - Marcio - 06-16-2015 10:47 AM
RE: [WP 34s] Trapezoidal approximation of area under curve - Dieter - 06-16-2015, 11:31 AM
RE: [WP 34s] Trapezoidal approximation of area under curve - Thomas Klemm - 06-16-2015, 12:38 PM
RE: [WP 34s] Trapezoidal approximation of area under curve - Marcio - 06-16-2015, 12:57 PM
|
User(s) browsing this thread: 1 Guest(s)