HP41 : Zenrom Synthetic programming : Syntext

[highfell]

(08-27-2023 09:53 PM)Diego Diaz Wrote:  Hi there,

From the ZENROM manual: Chapter 4.1 page 54.
"pressing [.] places 'ST' in the display you may now press any of the 16 letter keys
(T,Z,Y,X,L,M,N,O,P,O,R,a,b,c,d,e) to get the corresponding postfix byte appended as
part of the function."

In short, to your example, to enter STO M just press [STO] [.] [RCL] (RCL is the key for "M") and you'll get STO M in your program.

It works the same in RUN or PGRM mode.

Hope this helps.

Best

Diego.

Thanks Diego. I remember seeing this but I didn’t understand the significance or relevance to my difficulty ! Still really enjoying your Nov64d - an amazing piece of engineering.